Slope Ratings With Real Weight: A Derating Table for Heavy Users
Published climbing angles are measured at a standard mass β usually the 100 kg test dummy. Users heavier than the test mass climb less, brake longer, and tip easier, and the derating is calculable. This article gives you the arithmetic and the table.
Where the capacity goes
Climbing torque demand is proportional to total mass times sine of the slope angle. At 10 degrees, sin is 0.17: every 10 kg of extra user mass adds roughly 17 kg of down-slope force the motors must fight, on top of rolling resistance (about 2-4% of total mass) and acceleration demands. Two ceilings bite: motor thermal/current limits (the controller caps output) and traction (drive tires begin slipping when demanded force exceeds friction, which itself is proportional to the load ON the drive wheels β which weight shifts). The lower of the two is your real climbing angle.
The derating table
For a folding power chair rated 12 degrees at 100 kg (mid-drive, rubber tires on dry asphalt, sustained climb):
- User 80 kg: about 13-14 degrees (rating headroom)
- User 100 kg: 12 degrees (rated condition)
- User 115 kg: about 10-11 degrees
- User 130 kg: about 8-10 degrees
- User 145 kg near a 150 kg capacity limit: 7-8 degrees, and expect thermal derating on long climbs
On wet surfaces cut traction-limited figures by a further 20-30%. On grass or gravel, 30-40%.
What this means against real-world slopes
- Accessibility ramps at code maximum (1:12, 4.8 degrees): any certified chair at any user mass. Not a constraint.
- Common parking garage ramps 8-10 degrees: fine at 100 kg, marginal at 130 kg β momentum helps, heat hurts.
- Steep residential driveways 12-15 degrees: heavy users need run-up and pauses, or a different route.
- Boat ramps and rural gradients above 15 degrees: heavy-user territory only for high-torque heavy-duty models, full stop.
Braking and stability derate too
The same extra mass lengthens braking distances (roughly proportional to mass at equal braking torque) and moves stability margins: a rear-biased heavy user descends more safely backward, but never rotate to face downhill mid-slope β complete the turn on the flat. Anti-tippers' engagement angle stays fixed while the tip threshold drops, meaning anti-tippers that never touched ground at 80 kg may drag constantly at 140 kg. Reassess the whole geometry after major weight changes, including new equipment carried on the chair.
Buying for a heavy user, the right questions
Ask: climbing angle at the ACTUAL user mass (reputable suppliers will test or state derating); motor type and continuous torque, not peak watts; battery position (under-seat mid-frame preserves stability as mass rises); and the frame's declared capacity with margin β running a chair permanently at 95% of capacity consumes frame, bearings and brakes at triple the design rate. Our 5000 heavy-duty platform is rated 150-180 kg with torque curves published per motor β because a 12-degree line on a chart is a promise only when it comes with its test mass.