J&J MOBILITY
NEWS Nov 21, 2026 3 min read

Inside Wheelchair Factory QC: AQL Sampling and the 100% Test Items

J&J MOBILITY
Inside Wheelchair Factory QC: AQL Sampling and the 100% Test Items

Quality in wheelchairs is not a certificate on a wall β€” it is a set of daily routines on the line. Understanding them tells you which suppliers can back their promises with data. Here is how our production line verifies chairs, which generalizes to any competent factory.

The two-layer system: sampling plus 100% checks

Incoming components (motors, controllers, batteries, chargers) are inspected per lot under ISO 2859-1 AQL sampling β€” typically AQL 1.0 for critical components (controllers, batteries), AQL 2.5 for general parts. AQL 2.5 means: from a lot of 500, sample 50; accept up to 3 defects, reject the lot at 4. Rejected lots return to the vendor β€” the discipline that actually drives supplier quality, not the certificate audit once a year.

What is tested on 100% of finished chairs

  • Electrical safety function: power-up self-test, controller fault codes clean, e-stop (electromagnetic brake engagement on power-off) verified on every unit β€” a chair that coasts on power loss never ships.
  • Charger cycling: one full charge-check cycle per unit, confirming charge termination and state-of-charge reporting.
  • Drive test on roller: forward/reverse at load, speed check against calibrated roller (within 10% of spec), current draw logged β€” outliers flag bearing or gearbox issues invisible to the eye.
  • Brake performance: stopping distance from max speed on the roller bench, per unit.
  • Controller programming verification: profile parameters read back and matched to the model's released configuration.
  • Fit and finish: folding lock, seat attachment, armrest and footrest hardware torque check via driver bits set to spec.

What is sampled (destructive or time-intensive)

Fatigue and structural verification runs per ISO 7176-8 on samples from each production batch β€” the double-drum 200,000-cycle and drop-test program β€” with results retained per batch. Salt-spray corrosion on frame samples per finish lot. Battery packs: capacity audit sampling (2-5% of packs discharged to verify Ah) beyond the mandatory cell-level UN 38.3 and BMS function checks which are 100% at the pack assembler.

The data trail a buyer should request

Per order: final inspection report (sample plan, results), roller test statistics for your lot (mean and spread of current draw at load β€” a tight spread is the fingerprint of consistent gear-motor assembly), and the batch reference linking your serial numbers to frame fatigue samples. Suppliers with this trail can answer warranty questions with data; suppliers without it answer with apologies.

Pre-shipment inspection (PSI) and how to make it useful

Third-party PSI (SGS/BV/TUV class) typically re-runs AQL 2.5/4.0 sampling on your lot. Make it useful by aligning the checklist with functional items β€” power-off brake engagement, folding lock, speed check β€” not just cosmetic AQL. A PSI that only counts scratches certifies nothing about whether the chairs work. We build PSI stations into the packing area for exactly this reason: inspectors test, they do not just look.

What this means for tenders and institutional buyers

Specification language worth copying: "Supplier shall provide per-lot final inspection reports and 100% functional test records, batch-linked structural verification per ISO 7176-8, and retained samples for the contract term." One sentence converts quality from adjective to evidence β€” and separates factories that measure from factories that describe.

Share this article